Sailing Waterproof Anorak - Waterproof Windproof Anorak SAILING 100

We measure the fabric resistance to water pressure in mm of water column (based on the JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is.On our Sailing 100 jacket:Component is resistant to water pressure of 5,000 mm Schmerber (JIS standard). This equates to the average pressure applied by the water during a rain shower.The anorak’s waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.

- High collar- Injection-moulded plastic to avoid salt oxidation- Water-repellent components (water runs off the fabric)- 100% taped seams- Central opening features a flap with a drainage channel for optimal waterproofing

The hood does not pack down into the collar, it is attached.Completely depth and height-adjustable hood.Visor with a headband to provide a good level of protection and a better hold.The high neck effectively protects the neck.

2 zip pockets on the front of the jacket to put your hands or some items1 inside pocket on the right side of the chest with a rip-tab closingNOTE: the pockets are NOT WATERPROOF

A zip on the entire jacket length with an interior flap protects against the wind and water.Soft fabric flap on the top of the collar to protect the chin.

To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric’s resistance, the more moisture is evaporated, and therefore the higher the fabric’s breathability.We consider that if:RET < 9 = highly breathable fabric9 < RET < 12 = breathable fabricThe RET of the Sailing jacket 100 is 12.

A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.

To maintain the water repellent properties, infrequent washing is recommended.Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full rinse cycle or extra rinse.

Drying is a crucial phase in reactivating the water repellent treatment.We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.Then place them in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.